The condensation clamp is wrapped in rubber. The condensation clamp is wrapped with rubber, which increases the friction and effectively clamps the vessel.
The torque can be adjusted automatically according to the change of sample viscosity. High and low speed, accurate and controllable.
The LCD displays the set value and actual value of the speed, and can monitor the speed and time in real time. Large mixing capacity (H, O): 40L.Torque: 60 (N / CM). It is a good tool for petroleum, chemical industry, metallurgy, textile, food, medicine and health, environmental protection, biochemical laboratory, analysis room, education and research. Dimensions: 46 36 17 CM.
Drilling chuck clamping diameter range [VAC]: 0.5-10. DIN EN60589 protection method: IP42.Allowed ambient temperature [° C]: 5-40. Allowed ambient humidity [%]: 80. Press and hold the right button to boot, press the set button to select the setting.
Press the set button once, the mode flashes, press the upper and lower two buttons in the middle to select the mode, a total of three modes corresponding to different speed and time. Select the mode mode, press the set button again, Rpm flashes and use the up and down keys to set the required speed per minute.
After setting the speed, press the set key, Min flashes, use the up and down keys to set the required timing time, after starting, the speed reaches the set speed, and the timing starts timing. Set the above parameters in a certain mode, long press the set key, the screen flashes, indicating that it has been stored in this mode, the next time you only need to select mode to correspond to the set speed and time, press the right button Start and pause, long press the key. Feedback is very important to us. It is impossible to address issues if we do not know about them!
Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount.Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday.